The GMX Devices can be place on copper and/or any type of plastic pipe. There are many ways to install the GMX devices. These pictures are just some examples. Questions, please call.

It is usually not possible to install two devices in a straight line on the flex line of a water heater. Notice the GMX devices are installed on the pipe without the shut off valve.

Close up view of the installation to the left.

Like on the previous water heater, it is usually not possible to install two devices in a straight line on the flex line of a water heater. Notice the GMX devices are installed on the same side of the pipe and on the outside of the curve.

Close up view of the installation to the left.

This is a single device installation on a 40 gallon water heater. The GMX device is installed right up next to the wall. The straightest section of flex pipe.

This is an ideal water heater installation. 3" from each elbow.

A 75 gallon water heater prior to installing two (2) GMX Model 800 device on the output (hot) pipe. The output (hot) pipe is the pipe without the water shut-off valve.

The same 75 gallon water heater after installing the two (2) GMX Model 800 devics on the output (hot) pipe. The shut-off valve (cold water in) can be seen right of the GMX devices on the other pipe in close up # 1.

Both units MUST be installed on the same side of the pipe as shown, with the arrows pointing the same direction. The arrows are on the far side of the devices in close up # 3 and cannot be seen. In close up # 3, the devices are touching each other on the right side and there is a 1" separation on the left side.